ANTOR 3LD510 - Page 32

32
7. MAINTENANCE
Cleaning the engine cooling fins (*)
EVERY 250 HOURS
Clean the cooling fins of cylinder and
cylinder head with a brush and
kerosene.
(*) NOTE :
Depending of engine version removal of rope
pulley, flywheel,air shroud, air filter,exhaust muffler
and side panels may be necassary to clean the
cooling fins. These operations necessitate special
tools and skills and must be done at authorized
service stations.
Dry the cleaned cooling fins
with compressed air.
Remove air shroud fixing
screws.
Remove ait shroud.