ANTTEQ AG24 - Network Configuration; Channel Setup and Scanning

Channels – Display the scan sub-menu
Channel installation modes.
Antenna – Set the signal type to antenna. When set to
Antenna, the TV can receive analog and digital (DVBT/T2)
broadcasting signals.
Cable – Set the signal type to cable. When set to Cable,
the TV can receive analog and QAM broadcasting signals.
Parental controls – Press button to select the option
then press OK button to enter the sub-menu.
Audio Channel – Press button to select the option
then press OK button to enter the sub-menu.
Open source licenses – Press button to select the
option then press OK button to enter the sub-menu.
Auto Channel Update
Channel installation mode – Select on-screen display
based on dierent
channel sources. You can select the signal type.
CHANNEL
Antenna
1.Menu->Settings->Channel->Channel Installation
Mode enter, choose Antenna.
2. Enter Menu->Settings->Channel->Channels.
3. 3. Channel Scan opens the ATV+DTV automatic
search platform interface of Antenna.
Update Scan: Re-automatically search for frequency
points outside.
Analog Manual Scan: Manual ATV search station.
After input the frequency point, you can select up or
down search station.
Single RF Scan: DTV manual search, left and right
after selecting RF Channel, directly OK search.
Cable
1. Menu->Settings->Channel->Channel Installation
Mode, select Cable.
2. Enter Menu->Settings->Channel->Channels.
1.Press the ‘’Network&Internet’’ icon.
2.Browse the desired conguration/Network.
3.Press the OK button to save and return to the previous
menu.
Network