Anwis Pleated Insect Screen User Manual

Moskitiera plisowana
Pleated Insect Screen
Insektenschutz Plissee
Wykaz elementów do montażu / Components for assembly / Teile zur Montage
Lp. / No. / Pos. Nazwa części Component Tiele
1 Moskitiera Insect Screen Insektenschutz
2 Szyna górna Top rail Obere Führungsschiene
3 Szyna magnetyczna Magnetic plate Magnetschiene
4 Szyna dolna Bottom bar Unterschiene
5 Zaślepka szyny magnetycznej Magnetic plate end cap Kappe für Magnetschiene
6 Klip montażowy Mounting clip Befestigungsclip
7 Wkręt 3,3 x 13 Screw 3,3 x 13 Schraube 3,3 x 13
1
2
3
4
5
6
7
1
Upewnij się że powierzchnia jest płaska.
Jej szerokość powinna wynosić co najmniej 40 mm.
Oczyść powierzchnię, na której ma być zainstalo-
wana moskitiera.
Make sure the installation surface is at and that
it is at least 40mm wide.
Clean the installation surface on which you will
mount the insect screen.
Stellen Sie sicher, dass die Leibung gerade ist. Ihre
Mindesttiefe muss mindestens 40mm betragen.
Säubern Sie, die vom Einbau betroenen Obe-
räche gründlich.
2
Włóż zaślepki.
Attach the end caps.
Setzen Sie die Abdeckkappen der oberen Führungsschienen ein.

Anwis Pleated Insect Screen Specifications

General

Brand	Anwis
Model	Pleated Insect Screen
Category	Insect Control Equipment
Language	English

Summary

Components for Assembly

Surface Preparation

Ensure installation surface is flat, at least 40mm wide, and clean.

Attach End Caps

Insert end caps into the top guide rails.

Installation Steps

Align and Fasten Top Rail

Align the top rail to the door frame and secure with tapping screws.

Prepare Sticky Tape

Remove the paper backing from the sticky tape.

Install Bottom Rail and Align

Install the bottom rail, align with the top rail, and attach.

Insert Screen into Top Rail

Place the main insect screen unit into the top rail.

Secure Screen to Frame

Pull the insect screen towards the frame and press it into the groove.

Unclip Main Part and Attach Plates

Unclip Main Part

Pull the posts to completely unclip the insect screen.

Screw Anchor Plates

Screw anchor plates by hand; do not use an electric screwdriver.

Align Unit on Anchor Plates

Align the main unit on the screwed anchor plates and press.

Insect Screen Adjustment

Adjust Stile Post Angle

Adjust the angle of the stile post.

Tighten Screw

Tighten the screw by hand; do not use an electric screwdriver.

Check Wire Tension

Check wire tension by gently pulling on the wires.

Adjust Wire Tension

Adjust wire tension by moving the screw along the groove.

Cleaning and Maintenance

Cleaning Instructions

Spray screen with water, clean with a brush, use mild detergent.

Drying and Wind Protection

Dry all parts thoroughly, leave screen open until dry.