Why is there a large error in the weight reading on my Anyload OCS-T?
A large error in weight readings on Anyload Scales can occur for several reasons. Ensure the scale was zeroed before applying any load by performing a manual zero. Verify that the unit is correct for your measurement needs and switch if necessary. The scale might require calibration, so perform a calibration. In some cases, this could be due to a defective loadcell or mainboard.
What to do if my Anyload OCS-T Scales do not power on after pressing the On/Off button?
If your Anyload Scales aren't powering on, there are a few potential causes. First, check and charge the battery, as it may be discharged or defective. If that doesn't work, the On/Off key might be defective; try pressing it harder and holding it for 2 seconds. Also, the power cable might be defective, so open the front panel and check it. It is also possible that the mainboard is defective.
Why does the display flash on my Anyload Scales?
If the display on your Anyload Scales is flashing, it is likely due to a discharged battery. Charge the battery to resolve this issue.
Details the function of each key on the scale interface, including Power, Zero, Tare, and Hold operations.
Describes the functions of keys on the remote control, mirroring scale operations like Zero, Tare, and Hold.
Explains the meaning of various LED indicators (STB, ZERO, TARE, HOLD) and unit indicators (lb, kg).
Lists system messages displayed on the scale, such as Idle Mode, Battery status, Password, and Power Off.
Instructions for powering the scale on and off, including initial checks and battery life display.
Procedure for manually zeroing the scale and notes on conditions that prevent zeroing.
How to tare the scale in gross mode (tare in) and net mode (tare out) with TARE light indication.
Instructions on locking the display reading to prevent changes and unlocking it.
Process for accumulating current weight readings, noting how gross or net weight is stored.
How to enter View mode to check accumulated weight or view high/low 5-digit displays.
Procedure for deleting the most recently accumulated weight, with confirmation messages.
Steps to clear all accumulated weights, with the 'Clr' confirmation message.
How to switch between units (kg, lb, User Unit) and indicator lights for each unit.
Setting the automatic power-off duration to conserve battery life, with options and default setting.
Adjusting the screen brightness level for better visibility and battery saving.
Configuring the idle mode delay to enter low-power consumption status.
To Next Page
General
