Anywire B2G78-PN1 - Page 32

I/O data
5-6
5.1.6. Slave unit designation (output)
Module name
ASLINK slave unit designation
b15
b14
b13
b12
b11
b10
b9
b8
b7
b6
b5
b4
b3
b2
b1
b0
ID and Param
Num (1)-(16)
R
Q
Designated ID (1)
Designated parameter number (1)
R
Q
Designated ID (2)
Designated parameter number (2)


R
Q
Designated ID (16)
Designated parameter number (16)
ID and Param
Num (17)-(32)
R
Q
Designated ID (17)
Designated parameter number (17)
R
Q
Designated ID (18)
Designated parameter number (18)


R
Q
Designated ID (32)
Designated parameter number (32)
ID and Param
Num (33)-(48)
R
Q
Designated ID (33)
Designated parameter number (33)
R
Q
Designated ID (34)
Designated parameter number (34)


R
Q
Designated ID (48)
Designated parameter number (48)
ID and Param
Num (49)-(64)
R
Q
Designated ID (49)
Designated parameter number (49)
R
Q
Designated ID (50)
Designated parameter number (50)


R
Q
Designated ID (64)
Designated parameter number (64)
Name
Content
Q
Parameter update start command
Switching this bit from OFF to ON starts updating the value
of designated parameter.
R
Update confirmation flag
A flag for confirming the update
Confirmation of the latest value is possible by writing an
inverted value of the update confirmation flag return signal
(L).
Designated ID (1)–(64):
ID number of slave unit subject to status details (1)–(64)/parameter (1)–(64) value setting
Designated parameter number (1)–(64):
Parameter number subject to parameter (1)–(64) value setting
0: Sensing level
1 or more: Parameter No.