19
Using the Antenna or Cable for your VCR
1. Turn off the power to the HDTV and VCR.
2. Connect the “Output to TV”, “RF Out” or “Antenna Out” connector on the
rear of your VCR to the ANTENNA/CABLE DIGITAL/ANALOG connector
at the rear of the HDTV.
3. Turn on the power to the HDTV and VCR.
4. Select TV using the INPUT button on the remote, side of the HDTV or
directly by pressing the TV button on the Remote Control.
Note: If you have an off-air antenna or cable TV, connect it to the
“Antenna In” connector on the rear of
our VCR.
To Next Page
Loading...
Need help?
General
