6
3. Operating Instructions
3.1 General Instructions
Press the power button to turn the monitor on or off. The other control knobs are located at front panel of the monitor.
By changing these settings, the picture can be adjusted to your personal preferences.
3.2 Control Buttons
Power
Press the Power button to turn on/off the monitor.
Clear vision/-
1. When there is no OSD, Press the “-” button to activate Clear Vision.
2. Use the “+” or “-” buttons to select between weak, medium, strong, or off settings. Default setting is always “off”.
3. Press and hold“-” button for 5 seconds to activate the Clear Vision Demo, and a message of “Clear Vision Demo:
on” will be display on the screen for a duration of 5 seconds, press Menu or Exit button, the message will disappear,
Press and hold “-” button for 5 seconds again, Clear Vision Demo will be off.
Clear Vision function will provides the best image viewing experience by converting low resolution and blurry images
into clear and vivid images.
Volume/+
When there is no OSD, press Volume button active volume adjustment bar, press - or + to adjust volume (Only for
the models with speakers).
Auto / Exit / Source hot key
When there is no OSD, press Auto/Source button continuously about 2 second to do auto configure. When the OSD
is closed, press Source button will be Source hot key function. Press Source button continuously to select the input
source showed in the message bar, press Menu/Enter button to change to the source selected.
To Next Page
Loading...
Need help?
General
