42‟‟ LCD TV AOC L42W781HS
Using the button, select the Skip option.
Using the < / > buttons, select On, the channel will be skip.
Skip : Allows to skip next channel when it is on, and Using the < / > buttons,
select store prog: ok.
Repeat this procedure to skip other channels.
Fine tuning : If the picture is not clear, you can adjust the setting.
Using the
button, select the Fine tuning option.
Using the < / > buttons to find the good tuning point.
Manual Search : Allows to launch a manual search.
Using the
button, select the Manual Search option.
Using the < / > buttons, start the search in decreasing or increasing order.
The search will stop at the first channel found.
If you wish to memorise the channel, select Store Program option using the
button and proceed as indicated in previous page. Otherwise, continue the
search using < / > buttons.
INPUT SELECTION
To select TV/VIDEO source:
To select desire input source, press the SOURCE button to display the
selection menu.
Using the
/ buttons to select each input sources.
Press the OK button to display the desire input source.
Digital TV Menu
First-Time Installation
When the system is first switched on, the Reference Application attempts to configure itself for the first time. This is
called ”First Time Installation”.
The user is then asked if they wish to perform an automatic tune for services. Automatic tuning functionality is
described later in this document. When the automatic tune finishes and services have been found, the lowest
number service is selected and a banner describing that service is shown. A user may have chosen not to perform
an automatic tune or no services may have been found by an automatic scan. In this instance the user may use the
“Main Menu” to automatically scan again or perform a manual scan. The Reference Application also provides the
facility for the user to force to trigger a “First Time Installation”. This facility can be found in the “Main Menu” under
the “Installation” option.
To Next Page
Loading...
Need help?
General
