Model
Document No. Version
Panel
Effective from Date Updated
NO
Amount
Diagram Tool Parameters
1 7B11-031013-00105111 3
Electric screwdriver
2 7B11-0412D6-20105111 1
4±1kgfcm
3 7B11-0306A6-00105111 15 Ф3×6mm flat-head black-zinc-plated machine screws
4 7B11-030616-00105111 2
5
Prepared by Reviewed by Approved by
Lin Liangjun
Project Controlled Seal
Recent
Modification
Record
Station Name
Back Cover Disassembling-1
Notice
1. Wastes produced by this station shall be placed in the assigned position. Refer to Waste Classification and Disposal List .
2. Install screws by the serial number (install one by one) and abnormalities such as screws being neglected, tilted and slipped are not allowed.
Take down the 1PCS Φ4×12 screws with an electric screwdriver.
Take down the 15PCS Φ3×6 screws with an electric screwdriver.
Take down the 2PCS Φ3×6 screws with an electric screwdriver.
Take down the 3PCS Φ3×10 screws with an electric screwdriver.
Section/Serial No.Unit Assembly 02
Part Number Descriptions Operations and Requirements
When finished, step on the switch with your foot to send the product to
next station.
Figure:
Φ3×6 countersunk-head black-zinc-plated machine
screws
Φ4×12mm round-head black-zinc-plated machine
screws with spring washers
Φ3×10 countersunk-head pointed-tail black-zinc-
plated tapping screws
Please read and understand the
operating instructions carefully
2
To Next Page
Loading...
