Model
Document No. Version
Panel
Effective from Date Updated
NO
Amount
Diagram Tool Parameters
1 Figure 1
2 Figure 2
3 Figure 3
4
5
Prepared by Reviewed by Approved by
Lin Liangjun
Project Controlled Seal
Recent
Modification
Record
When finished, step on the switch with your foot to send the product to
next station.
Figure:
Notice
1. Wastes produced by this station shall be placed in the assigned position. Refer to Waste Classification and Disposal List .
2. Install screws by the serial number (install one by one) and abnormalities such as screws being neglected, tilted and slipped are not allowed.
Part Number Descriptions Operations and Requirements
Station Name
Back Cover Disassembling-3
Pull out red/black and yellow/black speaker wires.
Pull out key board wire.
Take power cord and pass through power cord hole on back cover.
Section/Serial No.Unit Assembly 04
4
4Pi n
Yellow/black
speaker wire
Pull out red/black speaker wires.
Pull out remote control receiver
ard wire.
Take power cord and pass through
power cord hole on back cover.
Pull out yellow/black speaker wires.
Please read and understand the
operating instructions carefully
To Next Page
Loading...
