Model
Document No. Version
Panel
Effective from Date Updated
NO
Amount
Diagram Tool Parameters
1 7111-32L61F-41120J01 4 Figure 1
Electric screwdriver
2 7B11-030696-00101111 1
Φ3×6mm B-head nickel-plated machine screws
Figure 2
4±1kgfcm
3
4
5
Prepared by Reviewed by Approved by
Lin Liangjun
Project Controlled Seal
Recent
Modification
Record
Pull out all wires on mainboard.
Take down the screw with an electric screwdriver, then take down I/O
baffle plate and mainboard.
Figure:
1. Wastes produced by this station shall be placed in the assigned position. Refer to Waste Classification and Disposal List .
Section/Serial No.Unit Assembly 05
Part Number Descriptions Operations and Requirements
Station Name
Mainboard Disassembling
Notice
M3×7mm P-head white-zinc-plated machine screws
with spring and flat washers
5
Pull out all wires on mainboard.
OK
NG
Take down I/O baffle plate
and mainboard.
Hold the glue and then pull out
the wires.
Please read and understand the
operating instructions carefully
To Previous Page
Loading...
