AODELAN E3+ - Test Firing

9
Click "Icon" icon, locate and double click on the FIF le from the pop-out
window. Then it starts loading the new rmware.
1.3 The status of the upgrade will be displayed in the process bar. When
completed, an "Updata OK" will be displayed at the bottom of the upgrade
software window, and an “update OK” will be displayed on the receivers’
LCD screen. Upon completion, disconnect the USB cable and restart the E3
+
receiver.
Note:
Please ensure stable power supply when attempting to upgrade the E3
+
receiver. Loss of computer power during the upgrade process could fail
the upgrading.
Checking Version Info on E3
+
Receiver
You can check present version information on the E3
+
receiver: while
pressing power button to turn on the E3
+
receiver, press function button 1, 2
or 3 spontaneously until relevant version info is displayed on the LCD screen.
Function button 1, 2 and 3 is respectively corresponding to base hardware &
software version, RF hardware & software info, and Icon version.
Test Firing:
E3
+
receiver supports test ring function. You can trigger the ash attached
to E3
+
receiver by pressing test button< > on the receiver.