AODELAN E3+ - Lock Function

10
Attaching the E3
+
Receiver to Studio Lights or Flashes by
Cable
1) Turn off the ash/strobe and the E3
+
receiver
2) Connect a cable to the receiver’s 3.5 mm output port
3) Connect the opposite end of the cable to a ash or studio strobe
4) Turn on the ash/strobe and E3
+
receiver
5) Set the ash to Manual mode – no ETTL functions can be used when a
compatible ash is triggered by cable.
Lock Function
While the E3
+
receiver is on, press and hold power button and function
button 1 simultaneously for 2 sec to enable lock function. The function can
disable receiver’s button operation. And “LOCK!” will be displayed on the
LCD screen. Use this to prevent the receiver function settings from being
accidentally changed after you set them.
Again press and hold power button and function button 1 simultaneously for
2 sec, you can disable the lock function.