31
For printer stability and optimal results, please pay attention to the following matters :
For more information, please visit www.aoseed.com
IME3D filaments are recommended.
Do not change frequently the filaments
of different brands or types to avoid
nozzle jamming.
Please notice the supported versions.
The X-MAKER app may work with some
Android smartphones, but the experience
may be affected due to limited screen
width.
The recommended ambient temp for
using the printer is 0-35℃. If you don't
use it, please turn off the printer.
Close the glass door and don't reach
inside while the printer is in opertion.
Make sure there is no problem on the
first layer of the model after printing.
Do not block the air outlet on the top of
the printer during printing. Do not move
the printer while it's in operation.
To avoid unnecessary damage, never
disassemble the printer without following
professional instructions.
Notices
To Next Page
Loading...