15
Important Notifications:
1. Users and purchasers of electric wheelchairs must operate these devices
within electromagnetic environments. Failing to do so may result in mal-
functionality of the electric wheelchair.
2. Please be aware that the use of portable and mobile radio frequency
communication equipment may interfere with the normal operation of electric
wheelchairs. To ensure safe and effective usage, kindly adhere to the
recommended electronic environment guidelines.
3. Accessory and Cable Usage: Only use accessories and cables provided by the
manufacturer of the electric wheelchair. The use of accessories and cables other
than those specified may lead to increased electromagnetic emissions from the
electric wheelchair or reduced immunity.
4. Proximity to Other Equipment: Avoid using electric wheelchairs in close
proximity to other equipment whenever possible. If it is necessary to use them in
such a configuration, closely monitor and ensure they operate normally.
5. Warning Regarding Unspecified Accessories and Cables(Transducers): The
use of accessories and cables (transducers) not specifically designated as spare
parts for internal components may lead to an elevation in electromagnetic
radiation emitted by the electric wheelchair or a reduction in its immunity.
6. Identification of Electric Wheelchairs and Battery Chargers:
Each electric wheelchair and its corresponding battery charger are uniquely
identified through model numbers or other distinguishing information.
7. CAUTION
Should any of the following situations occur, immediately turn off the
wheelchair's power supply.
①. Movement other than that expected from the current operation. (For
example, moving backwards when the joystick is pushed forward.)
②. Brake failure
Let the chair rest for a minute or two, then turn the power back on, set the speed
range at the lowest level, and gently move the joystick. If the wheelchair does not
perform as expected, turn off the power supply and contact customer service.
(Note that the wheelchair can still be used in “manual mode,”as described
further on in this manual.)
To Next Page
Loading...