After using the unit:
1. After reworking, turn the air volume to max (99) and the tempera-
ture to the lowest settings.
2. Let the unit’s temperature reach 99 on the display or cool enough
to touch before turning off the unit, this is to protect the heating
element from wearing out too early.
3. Turn the Power Switch off
Replacing the Heating Element
1. Remove the screws located on the base of the nozzle.
2. Slide out the nozzle.
3. Detach heating element from its socket.
4. Place the new heating element to the socket..
Caution: Handle heating elements with care. Never rub the heating
element’s wire,
5. Assemble the Handle in the reverse order of disassembly .
6. Check all connections properly.
Note:
For 8032A++ the heating element's thermal sensor are the
red and blue wires , The two wires should have the same position ar-
rangement as the old heating element.
if the position of the red and blue wire is not the same , de-
tach these two wire and rearrange so that it is the same as the old heat-
ing element.
OPERATING GUIDELINES
8
To Next Page
Loading...