To Next PageTo Next PageWhat to do if my Aparici Water Heater shows error E2?
If your Aparici Water Heater displays error code E2, it means the appliance is operating without water in the tank. To resolve this, first, disconnect the power. Then, fill the water heater tank completely and plug the appliance back in. If the error persists after these steps, it is recommended to contact a qualified service technician.
General| Brand | Aparici |
|---|---|
| Model | SC N Series |
| Category | Water Heater |
| Language | English |
The water heater shall be built-in as close as possible to the outlets to reduce heat loses. Consider elbow reductions.
The water heaters can be installed in two positions: vertical or horizontal with maintenance cover on left side.
Connect to a closed-circuit pressure system. Use a return safety valve or equivalent to prevent overpressure.
Connect to electrical network using supplied plug. A switch must be installed to break both poles.
Electrical installation must fulfil CEI 64-8 standards. Appliances must follow indications for bathrooms and WC.
Water pressure must be between 1.5-5 bar. Also consider pipe quality for corrosion prevention.
Ensure the water heater is filled with water before plugging in. Operate as indicated and consider display.
Clean external parts with mild detergent. Do not use solvents or abrasives. Do not attempt self-repair.
In case of freezing risk, empty the water heater. Unplug, close inlet, drain using safety valve.
When the water heater fails, a fault code is displayed. Disconnect power and contact after-sales service.
