UPS Installation, continued
Step 3: Install
the Network
Management
Card
Caution: If you are installing the Management Card in a
Symmetra UPS that uses more than one APC
management peripheral, see the supplied
Installation
of Multiple Management Cards
sheet. You must
install the APC peripherals in the correct order,
otherwise the peripherals may fail to operate
properly.
1. Use the screws that hold the slot cover in place to secure
the Management Card in the UPS expansion slot.
2. Connect a network interface cable to the 10/100Base-T
network connector on the Management Card.
3. If neccessary, reconnect the PowerChute plus cable.
4. Reconnect the UPS to its input power source.
5. Turn on the UPS.
6. If neccessary, restart the PowerChute plus service.
7. See “Quick Configuration” on page 9.
Figure 1: Connecting a Management Card in a Smart-UPS
To Next Page
Loading...
