CHAPTER 3: MENU COMMANDS
12
Logging Menu (continued)
Menu Item Function
List Event Groups Lists the specific events in each group.
Power Events
UPS Control Events
User Activities
UPS Fault Events
Measure UPS Events
Clear Log Clears the view log. Does not clear the active event lists.
Status Menu
The Status menu displays information regarding load, battery and power modules, voltage, and electrical current.
Menu Item Function
Ø Vin Vout Iout Displays input voltage(s), output voltage(s), and output current information.
% load assuming
no redundancy
Compares the current load to the total capacity of all power modules.
% load allowing
for n+ redundancy
Compares the current load to the total capacity of all power modules except the power
modules that are set aside by the “Fault Tolerance” alarm threshold. For example, if
there are four power modules installed, and the fault tolerance alarm threshold is set
to “1,” this percentage of load uses only 3 power modules for the calculation. See
Setup-Alarms to set the redundancy level.
Frequencies Displays the measured input and output frequencies.
Battery Status
Screen
Displays battery module capacity, runtime, and status information.
Power Module
Status Screen
Displays power module capacity, fault tolerance, and status information.
Alarm Thresholds
Status Screen
Displays the user-defined alarm settings. See Setup-Alarms to set these alarm
thresholds.
Miscellaneous
Status Screen
Displays the summary result Self Test, Last System Transfer, Operating Mode, and
status of Intelligence and redundant intelligence modules.
To Next Page
Loading...
