APC PDU - User Manual

PDU Branch Current Monitoring Board
Installation and Configuration
Inventory
Safety
Mounting the board in the PDU
The branch current monitoring board mounts to brackets in the PDU on the right and left side of each
circuit breaker panel. The illustration in step 2 on page 2 shows the mounting brackets on the upper
right-hand side of the PDU circuit breaker panel.
(1) (1)
(3)
(3)
Note
The branch current monitoring board can be installed only in a PDU with a serial
number of XF0314 or higher.
Electrical
Hazar
d
Before installing the branch current monitoring board, ensure that your system is
not receiving power (Total Power Off).

APC PDU Specifications

General

Input Frequency	50/60 Hz
Dimensions	Varies by model
Weight	Varies by model
Product Type	PDU
Form Factor	Rackmount
Input Voltage	100-240V
Output Voltage	100-240V
Output Connections	IEC C13, IEC C19
Input Connection Type	IEC 60320 C14, IEC 60320 C20
Maximum Load Current	16A, 20A, 30A
Number of Outlets	8, 12, 24
Mounting	Rackmount
Rack Height	1U, 2U
Operating Temperature	0°C to 50°C
Operating Humidity	5% to 95% non-condensing

Summary

Inventory

Safety

Electrical Hazard

Ensure the system is not receiving power before installation.

Mounting the board in the PDU

Installation

How to mount the board in the PDU

Details the steps for physically attaching the branch current monitoring board within the PDU.

How to route power cable wires

How to connect the board to the monitoring unit

Configuration

Panel Configuration

Configure branch metering settings for individual circuit breakers or panels.

Global Panel Config

Configure circuit breaker ratings for all circuit breakers simultaneously.

Specifications

APC Worldwide Customer Support