A B
Connecting the Speaker
1. Connect a two-pole (+/-) loudspeaker cable to the binding posts, located at rear of the cabinet. The high
quality, gold plated binding posts can accommodate different connection systems:
•Banana plugs: The pins can be put directly into the binding post without any tightening necessary.
•Cable spades: Loosen the binding posts, insert the spade into the opening, and secure the spade by
tightening the posts.
•Bare wires: Loosen the binding posts and place the cable into the binding posts. Tighten the posts.
2. Connect the other cable ends to the loudspeaker outputs of your switched off power amp.
The loudspeaker cable can have an impact on sound quality. In general, quality cable products will yield a
quality result. Make sure to keep the cable length as short as possible. We recommend the use of at least
14 AWG diameter for distances < 15m. Please make sure that all connectors are clean and not oxidized.
Connecting the Speaker
1
Connecting surround speakers
When connecting a two-channel stereo system, only the right and left channels are connected to the
amplifier. In a surround set-up, center, side or rear loudspeakers as well as a subwoofer are typically
connected to provide for a multi-channel listening experience. Please refer to the amplifier’s owner manual
for particular connection instructions.
To Next Page
Loading...