Apple Computer Monitor User Manual

Unpacking and wall mounting instructions
For the unpacking instructions follow the illustrated steps 1 to 5 printed
on the packaging (outside and inside).
For the wall mounting instructions follow the illustrated steps 6 to 8
printed on the first pages of this instruction booklet.
Make sure that the wall mount is being fixed securely enough so that it meets
safety standards.The weight of the monitor (excl. packaging) is about 43 kg.
Connect your computer
&
Connect one end of the VGA cable 1 supplied to the video card of the
computer and the other end to the
VGA IN connector at the rear side of the
monitor. Fix the connectors firmly with the screws on the plug.
é In case of a Multimedia computer, connect the audio cable 2 to the audio
outputs of your Multimedia computer and to the
AUDIO IN R (right) and L
(left) inputs of the monitor.
“ Connect one end of another VGA cable 3 to the VGA OUT connector at
the rear side of the monitor and the other end to the
VGA IN connector of a
second VGA monitor.
Daisy chaining
The Active Loop Through facility makes it possible to make a daisy chain with
a second VGA monitor.
‘ In case of a Multimedia computer, also connect the audio cables 4 to the
AUDIO L and R outputs of the monitor and to the AUDIO IN L and R inputs
of the second VGA monitor.
Note: only use the VGA cables supplied or use cables that are specially delivered
with the monitor.
Connect your Apple Macintosh* computer
Attention: Macintosh computers with separate H and V synchronisation signals
can be used together with the supplied adaptor. Macintosh computers with
Composite Sync and Sync on Green signals may need a special (not
supplied) adaptor or cable. Contact your dealer.
Connect the supplied switchable adaptor for Apple video connectors to one
end of a VGA cable.
Put the DIP switches on the adaptor in the following positions :
1234
off off on on
Connect the end of the VGA cable with the adaptor to the video card of the
computer and the other end to the
VGA IN connector on the back of the
monitor.
Screw the connectors down firmly.
* Apple Macintosh is a registered trademark of Apple Computer, Inc.
1
15-pin D sub
(2-row)
15-pin mini D sub
(3-row)
a
MAINS INLET
VGA IN
AUDIO IN
L
R
VGA OUT
5
1 32 42
AUDIO OUT

Apple Computer Monitor Specifications

General

Pixel Density	218 ppi
Wide Color Gamut	P3
Refresh Rate	60Hz
Display Size	27 inches
Resolution	5120 x 2880
Color Support	1 billion colors
Ports	Thunderbolt 3, USB-C

Summary

Unpacking and Wall Mounting Instructions

Unpacking Guide

Follow illustrated steps on packaging for unpacking the monitor.

Wall Mounting Guide

Follow illustrated steps for wall mounting and ensure secure fixing to meet safety standards.

Connecting Your Computer

Standard Computer Connection

Connect VGA and audio cables from the computer to the monitor's respective inputs.

Daisy-Chaining Monitors

Utilize VGA OUT to connect a second monitor for daisy-chaining with Active Loop Through.

Apple Macintosh Connection

Connect using a switchable adaptor and configure DIP switches for Apple computers.

Computer Display Modes

Supported Display Modes

Lists supported VGA, MAC II, SVGA, and XGA display modes with resolutions and frequencies.

Monitor Operation

Powering On the Monitor

Insert the mains plug and press the power button to turn the monitor on.

Remote Control Battery Setup

Install the supplied batteries into the remote control's battery compartment.

Using the Remote Control

Remote Control Functions Overview

Details functions of remote buttons like MENU, OK, cursor keys, Picture Format, and Mute.

VGA Menu Navigation

Learn to switch the VGA menu on/off and adjust settings like contrast and brightness.

Tips and Troubleshooting

General Usage Tips

Advice on ambient temperature, screen care, plasma characteristics, and peripheral interference.

Troubleshooting Common Issues

Guidance for issues like no picture/sound, unstable VGA signals, and remote control problems.

Transport and Disposal Guidelines

Instructions for transporting the monitor and proper disposal of batteries and the unit.