Apple IIe - Page 79

Applesoft BASIC Programming 79
STOPPING PROGRAM EXECUTION
A number of different methods are available for stopping
program execution on the lie . These will be discussed in the
following sections.
Control-C
A program can be stopped by pressing the Control and C keys
simultaneously.
If Control-C is pressed in response to an INPUT
statement
prompt, the Return key must be pressed after
Control-C to stop execution.
When program execution is stopped by pressing Ctrl-C, the
following message will be displayed (in Applesoft BASIC):
' BREAK IN
line number
The line number will be the line number where the program
execution was stopped. Program execution can be resumed by
entering CONT.
In Integer BASIC, the following message will be displayed when
program execution is 'Stopped using Ctrl-C.
STOPP~D AT line number
Again, line number indicates the l~ne where program execution
was stopped. Program execution can be resumed by typing in
CON.
END
The END statement can be used to stop program execution.
Progam execution can be resumed once END has been executed
by
entering CONT. In Integer BASIC, program execution cannot
be resumed once END has been executed.