Apple IIe - Page 99

Apple BASIC Reference Guide 99
Example
10 DSP A
20 DSP B
30 A= 1
40 B =7
50 C = A*B
60 B =C+A
70 END
]RUN [Ret]
#30 A= 1
#40 B =7
#60 B = 8
IJ1 the preceding example, the line number, variable, and
variable values are displayed
when the indicated variable's
values change.
Notice that in line 50 the value of A and Bis used,
but not changed, so it is not displayed.
•
Applesoft
END
• Integer
The END statement is used to stop program execution.
Configuration
END
The END
statement is optional in Applesoft. If it is not used, the
program will stop execution at the highest line number .
The END
statement is optional in Integer BASIC, but if it is not
included a NO END error will result. The program will essentially
run the same with or without the END statement.
Example
999 END