16 -
Testing Procedures
iPod mini
CHGRCUR
1. Skip this test.
REMOTE
1. Plug in the remote control.
2. Start the test, and press all 5 buttons on the remote control, in any order, within 5
seconds: Play/Pause, Next, Previous, Volume up, Volume down.
3. A Pass condition shows the following screen:
HP STAT (headphone status)
1. Press the Select button to see the following screen:
2. For HP (Headphones), 0 = Not connected, 1 = Connected
3. For HOLD (Hold switch), 0 = Off, 1 = On
4. Plug in the headphones, and the HP value will change to 1.
5. Turn on the Hold switch, and the HOLD value will change to 1.
6. Pass the iPod if it behaves as indicated. (
Note:
Verify the Hold switch is off.)
IRAM3
It will take a few minutes to complete this test. If the test passes, PASS will be displayed.
UARTTEST
HP OK
UARTPASS
NEXT PRE
+ -
HPDETECT
HP 0
HOLD SW
HOLD 0
To Next Page
Loading...
