5
Important Information
About Your Studio Display Cable
Connecting Your Display to Your Computer
The connector on your display cable is a VGA video connector (shown below). All references
to the monitor connector (2-row D-15 video connector) in the user’s manual are replaced by
the information presented here. For instructions on connecting your display, see the user’s
manual that came with your display.
Connecting Your Display Using the VGA-to-Mac Adapter
To connect your display to a computer or graphics card with a Macintosh-type connector
(2-row D-15 connector), or to a graphics card with both VGA and Macintosh connectors, you
need to use the VGA-to-Mac adapter that came with your monitor. See the following
illustration.
1 Connect the Macintosh (2-row D-15) end of the adapter to your computer or graphics card
and tighten the thumbscrews.
Monitor port icon
Connector on
display cable
To Next Page
Need help?
General