Adjustments Diagnostic Adjustments - 32
3 Select the default 9300 white point and click
Recalibrate.
• If you later choose another white point such as 6500
or D50, you must click Recalibrate for the changes to
take effect.
• If the display looks blurry after recalibrating, adjust
convergence as described in the previous section.
• If you hold down the option key and click Factory
Settings, it might be necessary to perform a minor
convergence adjustment using Monitors & Sound
control panel.
4 If the Recalibration fails, a warning message will
appear. Click OK and click Recalibrate again.
5 If the recalibration fails again, use the duplicated file to
upload the parameter settings. (Hold down the option key
and drag the Parameter Settings MBY file out of the
Parameter File Backup folder; then follow the procedure
To Next Page
