13
Rework/ Factory Data
1. “Rework > Factory Data > Upload All”- Uploads all the whole UUT EEPROM data
and stores the data in the factory file format. Can be used to backup EEPROM data
prior to changing of video board to minimize re-alignment
2. “Rework > Factory Data > Download All”- Downloads all the data stored in a valid
factory file format and writes the data into the UUT EEPROM. Can be used during
the repair process to transfer the UUT data into a new video board.
3. “Rework > Factory Data > Convert to Excel format”- Converts a UUT factory backup
file to a excel readable format.
4. “Rework > Factory Data > Convert to Excel format”- Converts a UUT factory backup
file to a simple text readable format.
Quantum Data
1. “Quantum Data > 801 Formats >”- For serial control of the Quantum 801timing
modes/ formats.
2. “Quantum Data > 801 Patterns >”- For serial control of the Quantum 801 patterns.
3. “Quantum Data > 801 Controls >”- For serial control of the Quantum 801 controls.
Minolta
1. “Minolta> Setup >”- For serial control of the CA100. Initialization and zero probe
should be performed prior to the software white balance adjustment functions and
VPT calibration functions.
2. “Minolta > Channel >”- For serial control of the CA100 channel selection.
To Next Page
Loading...
