Apple Universal Dock - Apple Remote Management; Pairing and Resetting the Dock

11English
Note: You can’t use the remote to choose a dierent playlist. Use the iPod or iPhone
controls instead.
The Apple Remote works with other compatible Apple products that have a built-in
infrared (IR) receiver. You can pair your Dock to work only with a particular remote, so
remotes for your other devices don’t aect the Dock.
To set the Dock to work with only a particular remote:
1 Place your iPod or iPhone in the Dock and press any button on your iPod or iPhone
to turn it on.
2 Make sure other products that are compatible with the Apple Remote are out of range
or powered o, and then hold the remote close to the IR receiver on the Dock (within
3 to 4 inches, or 8 to 10 cm).
3 Press and hold the Right button and Menu (») button on the Apple Remote for
ve seconds.
Your Dock now works only with the paired remote.
Note: You may want to pair your other Apple Remote compatible devices with
other remotes, so the remote you use with your Dock doesn’t aect those devices.
For instructions, see the documentation that came with those devices.
To reset the Dock to work with other Apple Remotes:
m Follow steps 1 and 2 above. Then press and hold the Left button and Menu (»)
button on the Apple Remote for ve seconds.
The Dock now works with any Apple Remote.