SYST:ENER:IMP:MOD?
Request for the state of the device impulse output. Reply is number: 0 … state is FIXED, 1 … state is
ACTIVE POWER, 2 … state is REACTIVE POWER, 3 … state is APPARENT POWER
SYST:ENER:IMP:MOD {<mode>}
Setting the state of device’s impulse output. Parameter is number: 0 … state is FIXED, 1 … state is
ACTIVE POWER, 2 … state is REACTIVE POWER, 3 … state is APPARENT POWER
SYST:ENER:IMP:AUX?
Request for the state of AUX output. The same parameter as described in Measurement Settings.
Answers are: 0 = OFF, 1 = ON.
SYST:ENER:IMP:AUX {<auxiliary>}
Setting of the state of AUX output. The same parameter as described in Measurement Settings.
Parameter can be 0 = OFF, 1 = ON.
SYST:ENER:DOS:INIT
Initialization of dosage function.
SYST:ENER:DOS:STAR
Start (or initialization) of dosage function.
SYST:ENER:DOS:STOP
Stop (or cancel) of dosage function.
SYST:ENER:DOS?
Request for general status of dosage function. If dosage function is active reply is: percentage, done
energy or time and full energy or time.
SYST:ENER:DOS:STAT?
Request for status of dosage function. Reply is 0 (dosage not active), 1 (dosage initialized), 2 (dosage
started and running) or 3 (dosage stopped).
SYST:ENER:DOS:STAT:PERC?
Request for done percentage of dosage.
SYST:ENER:DOS:STAT:VAL?
Request for done value (time or energy amount) of dosage.
SYST:ENER:DOS:STAT:TIM?
Request for time of “time dosage” in seconds.
SYST:ENER:DOS:STAT:ENER?
Request for energy of “energy dosage” in Ws resp. VAs.
SYST:ENER:DOS:STAT:ENER:K?
Request for done energy of “energy dosage” in kWh resp. kVAh.
SYST:ENER:DOS:MOD {<mode>}
Setting of Dosage Mode. Parameter is number (0 - 5) or code (TIME, ACTIVE …) of Dosage Mode.
SYST:ENER:DOS:MOD?
Request for state of Dosage Mode. Answer is number (0 - 5) or code (TIME, ACTIVE …).
To Next Page
Loading...
Need help?
General
