Need help?Do you have a question about the Apprentice AJS40 and is the answer not in the manual?
General| Brand | Apprentice |
|---|---|
| Model | AJS40 |
| Category | Power Tool |
| Language | English |
Always use safety glasses with side shields; ordinary glasses are not sufficient.
Always remove keys and wrenches before starting the tool to prevent injury.
Ensure the switch is in the 'OFF' position before plugging in; move to 'OFF' during power failure.
Use clamps or a vise to hold the workpiece securely for safer operation.
Turn the power off and wait for the machine to stop completely before leaving.
Disconnect power before adjusting, changing setups, or making repairs.
Use correct blades with proper arbor holes and avoid defective washers or bolts.
Double-check all setups before cutting, ensuring the blade is tight and clear.
Keep hands away from the blade and moving parts while the tool is in operation.
Ensure no rotating component contacts the workpiece before starting the tool.
Use respiratory protection and ventilation when dust exposure may cause serious health risks.
Strict adherence to safety rules is required, even with repeated use, to prevent injury.
Ordinary eyeglasses are not safety glasses; use certified eye protection.
Make sure the blade does not contact the workpiece before turning the switch on.
Always keep hands away from the blade and other moving parts during use.
Operate the tool only when hand-held; never leave it running unattended.
Switch off the tool and wait for the blade to stop before removing it from the workpiece.
Avoid direct eye exposure to laser light; never aim at people or reflective surfaces.
Adjust tool speed from 500-3,000 SPM using the dial for different materials.
Follow procedure to securely install or remove saw blades using the tool-less collet.
To Next Page