67
use and maintenance RS 50 Tuono
BULBS
Carefully read p. 39 (MAINTENANCE).
CAUTION
Before changing a bulb, turn the
ignition switch to position “
”.
Change the bulb wearing clean gloves
or using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage.
If you touch the bulb with bare hands,
remove any fingerprint with alcohol, in
order to prevent it from blowing.
DO NOT FORCE THE ELECTRIC
CABLES.
CHANGING
THE HEADLIGHT BULBS
Carefully read p. 67 (BULBS).
◆
Position the vehicle on the stand.
NOTE Before changing a bulb, check
the fuse, see p. 63 (CHANGING THE
FUSE).
The headlight contains:
◆
One high beam bulb (1) (right side).
◆
One parking light bulb (2) (lower side).
◆
One low beam bulb (3) (left side).
The high beam and the low beam bulbs are
equal to each other. If either of them is
damaged and no spare bulb is available, it
is possible to invert them.
This operation is intended only to make it
easier for the rider to go back home or to
reach a shop where he can by a new bulb,
but the replacement of the damaged bulb
remains indispensable.
To change the bulbs, proceed as
follows:
PARKING LIGHT BULB
CAUTION
To extract the bulb socket, do not pull
the electric wires.
◆
Working on the rear side of the front part
of the fairing, seize the bulb socket (4),
pull it and remove it from its seat.
◆
Withdraw the parking light bulb (5) and
replace it with one of the same type.
To Next Page
Loading...
Need help?
General
