9 www.Aprimatic.it
4.4 INSTALLATION OF OVER EVO AUTOMATION WITH ARTICULATED ARM
Use the articulated arm to push with doors which open outside (view from the automation).
If the door has the hinge on the left, disassemble the gear motor group from the automation and move the spring group
from the left side to the right side of the automation, as described in chapter 4.5.
Hinge on the left Factory setting
Remove the cover and fix the automation in a stable and leveled way to the wall using the measurements shown in the
figure; refer to the axis of the door hinges.
Fix the bracket of the articulated arm on the door, using the measurements shown in the figure.
Note: if necessary, you can change the measure H, between the automation and the door, by replacing the spacer, using the
codes listed in the table.
(H) OVER EVO automation
30 Articulated arm + spacer H17
47 Articulated arm
64 Articulated arm + spacer H51
To Next Page
Loading...
