What to do if my Apxalarm APX32EN has no power?
If your Apxalarm Security System keypad has no display and the LED indicators are off, the system has lost power and is not working. Check the transformer connection and the powerline circuit breaker to restore power.
How to clear the 'OPEN' message on my Apxalarm APX32EN?
If your Apxalarm Security System displays 'OPEN' followed by zone numbers, it indicates an issue with those specific zones. After resolving the problem, clear the display by entering your security code and pressing the OFF key twice. This fault condition may also be due to environmental changes that are preventing the receiver from getting signals from a wireless sensor.
What to do if my Apxalarm APX32EN Security System beeps and shows 'LOW BAT' with a zone number?
If your Apxalarm Security System keypad is beeping every 45 seconds and displays 'LOW BAT' with a zone number, it means the wireless sensor in that zone has a low battery. Replace the battery in the displayed transmitter.
What does 'OPEN 103' mean on my Apxalarm APX32EN?
If your Apxalarm Security System displays 'OPEN 103', immediately call for service. This message indicates a range of critical issues, including: * Control panel lost communication with the communications module * Communications module tamper detected (cover removed) * Primary communications path failure * Radio is not registered; account not activated * Primary power loss * Secondary communications path failure * Battery charger failure * Low battery
What does 'FC' mean on my Apxalarm APX32EN?
If your Apxalarm Security System displays 'FC', it means a communication failure has occurred. This message will clear only when the system is subsequently armed.
General| Brand | Apxalarm |
|---|---|
| Model | APX32EN |
| Category | Security System |
| Language | English |
To Next Page
