Aqara Motion Sensor P1 User Manual

02
*
If adding fails, please move the product closer to thehub
and try again.
1.
2.
3.
4.
Before activating the accessory, please make sure you
have the Aqara Home app downloaded and an Aqara
Zigbee 3.0 hub installed.
Remove the insulating pull tab.
Pull the tab out from under the battery contact to the
direction of the arrow to activate the product.
Please open the app, tap “Home” and then tap “+” in the
top right corner to enter the “Add Device (Accessory)”
page. Select “Motion Sensor P1” and add it according to
instructions in the Aqara Home app.
Please see www.aqara.com/support for additional information.
Quick Setup
Please confirm that communication between the motion
sensor and the Aqara Zigbee 3.0 Hub works normally, and
then install and fix it in position.
Installation and Usage

Aqara Motion Sensor P1 Specifications

General

Detection Angle	170°
Battery Type	CR2450
Battery Life	Up to 2 years
Connectivity	Zigbee 3.0
Operating Humidity	0-95% RH (non-condensing)
Model	RTCGQ-13LM
Compatibility	Apple HomeKit, Aqara Home, Alexa, IFTTT
Detection Distance	Up to 7 meters (23 feet)
Mounting	adhesive