Aqua Flo Tub-Master Series User Manual

1. READ AND FOLLOW ALL
INSTRUCTIONS.
2. WARNING - To reduce the risk of injury, do not
permit children to use this product unless they are closely
supervised at all times.
3.
CAUTION - This pump is for use with permanently
installed pools and may also be used with hot tubs and
spas if so marked. Do not use with storable pools A per-
manently installed pool is constructed in or on the ground
or in a building such that it cannot be readily disassembled
for storage.
OWNER'S MANUAL
06/02
TUB-MASTER
®
SERIES PUMPS
When installing and using this electrical equipment, basic safety precautions
should always be followed, including the following:
A storable pool is constructed so that it may be readily
disassembled for storage and reassembled to its
original integrity and has a maximum dimension of
18 feet (5.49m) and a maximum wall height of 42
inches (1.07m).
4. Do not install within an outer enclosure or beneath
the skirt of a hot tub or spa unless so marked.
5.
SAVE THESE
INSTRUCTIONS.
IMPORTANT SAFETY INSTRUCTIONS
97490081

Aqua Flo Tub-Master Series Specifications

General

Brand	Aqua Flo
Model	Tub-Master Series
Category	Water Pump
Language	English

Summary

Important Safety Instructions

General Safety Precautions

Covers crucial warnings and cautions for safe operation, supervision, and handling of the pump.

Pool and Spa Usage Guidelines

Specifies approved usage with permanently installed pools, hot tubs, and spas, including dimensional limits.

Installation and Operating Instructions

Pump Installation and Location

Guides on proper pump placement, connection types, and installation requirements for optimal performance.

Pump Operation and Maintenance

Instructions for starting, priming, routine maintenance, and winterizing the pump to ensure longevity.

Troubleshooting Common Issues

Addresses frequent problems such as motor failure, overheating, priming issues, low flow, leaks, and unusual noises.

Replacement Parts Identification

Part Number Guidelines

Provides a system for identifying and ordering correct replacement impellers and wet end components using part numbers.

Pump Assembly, Disassembly, and Checks

Disassembly and Seal Replacement Procedures

Step-by-step guide for safely dismantling the pump, inspecting, and replacing seals, including the impeller.

Reassembly and Pre-Operation Checks

Detailed steps for reassembling the pump and essential checks before powering on for operation.

Warranty Information

Warranty Coverage and Exclusions

Outlines the limited warranty terms, coverage period, contact information, and common exclusions for the pump.