4
•
Screw Upper Brace of Entrapment Barrier into the
third step of the Inside Portion of the Ladder with
(2) #10 x 1-1/4” screws
•
Slide Upper Brace (AC 01125)
through the groove in the Large
Barrier and push down lightly to
secure.
•
Screw Lower Base of Entrapment Barrier into bottom
step of the Inside Portion of the Ladder with
(2) #10 x 1-1/4” screws.
STEP 3
•
Slide Upper Brace
(AC 01125) over Small
Barrier as shown.
•
Place the Lower Base (AC 01126) on a level surface.
•
Snap Large Barrier (AC 01123) into the groove on the lower
base facing round edge.
•
Snap Small Barrier (AC 01124) into the groove on the lower
base facing the straight side.
•
This Ladder is designed
to fit multiple pool heights. ONLY
FOLLOW THIS STEP IF YOUR POOL HEIGHT IS 48”.
•
Locate the leg (AC 01129) on both sides
of the ladder
.
•
Find the lines located at the top of the legs.
• Using a hacksaw cut both legs evenly alon
g the line.
FOR
48” POOLS, CUT ALL FOUR
LEGS AT THIS LINE
STEP 4
NOTE
Follow
this step if using as an In Pool Ladder
To Next Page
Loading...