How to troubleshoot an Aqua To Go AQUA Cold that does not operate?
If your Aqua To Go Water Dispenser is not operating, begin by ensuring it is properly plugged into a working power outlet and that the power switch is turned on. Also, check the power switch at the rear of the water cooler. Verify the power point is functional. Inspect the circuit breaker and fuses to see if any have tripped or blown.
What to do if my Aqua To Go AQUA Cold Water Dispenser has a water leak from the bottom?
If you notice a water leak from the bottom of your Aqua To Go Water Dispenser, remove the bottle and drain any remaining water from the cooler using the taps. Allow the cooler to sit overnight to ensure it is completely dry, and then try a new bottle.
How to fix a water leak from the taps of my Aqua To Go Water Dispenser?
To address water leaks from the taps of your Aqua To Go Water Dispenser, try tightening the leaking tap slightly by turning it clockwise. If this doesn’t resolve the issue, remove the bottle, drain the water, and fully unscrew the tap anticlockwise. Check the inside of the tap for any blockages, and then reattach it, screwing it clockwise.
What to do if water doesn’t flow from the tap of my Aqua To Go AQUA Cold Water Dispenser?
If water doesn’t flow from the tap of your Aqua To Go Water Dispenser, let the water cooler sit with a bottle on top for 1 hour. It can take up to 2 minutes for the first cup of water to flow from either tap. If the issue persists, there may be an air blockage. Try lifting the bottle up to let air in, or slowly rock the bottle and water cooler from side to side. Also, check if there is sufficient water in the tank or bottle, and ensure that the water intake isn't blocked and no water tube has a kink.
Why does the cooling system of my Aqua To Go AQUA Cold Water Dispenser turn on and off frequently?
If your Aqua To Go Water Dispenser's cooling system frequently turns on and off, it could be due to a hotter than normal room temperature. Another possible cause is an incorrect temperature control setting. Also, ensure the water cooler has sufficient clearance from the wall.
Why is the hot water not hot enough in my Aqua To Go AQUA Cold?
If the hot water from your Aqua To Go Water Dispenser is not hot enough, check that the heating switch on the rear of the cooler is turned ON.
How to remove bad taste from water in Aqua To Go AQUA Cold?
If the water from your Aqua To Go Water Dispenser has a bad taste, either at startup or after some time, fill the tank with hot water and mix in two tablespoons of baking soda. Let it sit overnight, and then rinse it out with fresh tap water the next day.
Why is my Aqua To Go AQUA Cold Water Dispenser not cooling enough?
If your Aqua To Go Water Dispenser is not cold enough, check that the cooling switch on the rear of the cooler is turned ON.
How to stop vibrations from my Aqua To Go AQUA Cold Water Dispenser?
If your Aqua To Go Water Dispenser is vibrating, make sure the cooler is placed on a level surface. If the vibrations persist, try placing the water cooler on a different floor surface to see if the vibrations stop.
Details technical specifications of the water cooler unit.
Crucial safety precautions to minimize risks during operation and maintenance.
Recommendations for selecting an appropriate and safe location for the water cooler.
Steps for flushing the cooler system before initial use.
Instructions for correctly installing a water bottle onto the cooler.
Guidance on safely connecting the water cooler to a power source.
Procedures for general cleaning and addressing water taste issues.
General| Brand | Aqua To Go |
|---|---|
| Model | AQUA Cold |
| Category | Water Dispenser |
| Language | English |
To Next Page
