8
Fig. 3
6. Please backfill fine sand (Depth≥110mm) at the bottom of the technical compartment
pit for shock absorption and noise level reduction.
7. Please backfill sand or concrete and then coping stone to fix the unit and decorate the
gap between compartment and the pool wall.
Prepare Indoor Control Panel Pit
1 The size for indoor control panel pit should be 280×180×100mm (Fig. 4)
2 Control panel is not water proof, is a must to install it indoor and never cover or wet it
Fig. 4
Connect The Control Panel To The Unit
1. Connect the cable to the junction box inside of the unit. (Fig. 5)
2. Connect the cable to the control panel.(Fig 5)
To Next Page
