Do you have a question about the AquaCraft Cajun Commander and is the answer not in the manual?
Radio System | 2.4GHz |
---|---|
Recommended Age | 14+ |
Speed Control | Electronic |
Material | ABS |
Power Source | Electric |
Battery Type | 7.2V NiMH |
Charger Type | AC Charger |
Do not swim after a stalled RC boat; it has flotation and will not sink. Use other retrieval methods.
Never operate the RC boat while standing in water or in the presence of swimmers.
Always use a PFD when boarding or operating retrieval craft such as Jon or duck boats.
Be very careful when working on and around the sharp running hardware, especially metal parts.
Pay close attention to the propeller when the motor is running; contact can cause serious injury.
AquaCraft products are to be used by ages 14 and over.
Specifications and descriptions are subject to change without notice; no responsibility for errors.
Thanks for purchasing; return immediately if unsuitable, but not after assembly or operation.
Lists required battery, charger, and AA batteries for the transmitter and boat.
Covers defects for 90 days; excludes damage from misuse or accidents. Contact local importer for support.
Details key features like ABS hull, LED lights, speed, and technical specifications of the boat.
Identifies the Tactic radio system and provides details on the 1800 KV brushless out-runner motor.
Charge the battery using the recommended method and install it securely into the boat.
Install AA batteries into the transmitter and turn it on to prepare for boat operation.
Use the switch on the side of the radio box to turn the LED lights on and off.
Follow the specific throttle and chime sequence to arm the boat before running.
Verify steering direction and briefly check motor operation for proper function.
Motor stuttering indicates low battery; bring the boat in immediately for charging.
Unplug the battery after each use and do not leave it plugged in for extended periods.
Remove and re-install the drain plug to allow any water to escape after operation.
Avoid operating on hard surfaces like concrete or ice to prevent permanent damage to the hull.
If the radio does not communicate, check servo reversing and throttle trim settings.
Clean with soft cloth, oil motor bearings, and store on a flat surface to prevent warping.