2
be used with hot tubs and spas with a water temperature under 50℃. Due to the fixed installation method,
this pump is not suggested to be used on above-ground pools that can be readily disassembled for storage.
1.10 The pump is not submersible.
1.11 Never open the inside of the drive motor enclosure.
WARNING:
• Fill the pump with water before starting. Do not run the pump dry. In case of dry run, mechanical seal will
be damaged and the pump will start leaking.
• Before servicing the pump, switch power OFF to the pump by disconnecting the main circuit to the pump
and release all pressure from pump and piping system.
• Never tighten or loosen screws while the pump is operating.
• Ensure that the inlet and outlet of the pump are unblocked with foreign matter.
To Next Page