Aquagem IP20 - Timer and Skimmer Modes

9
5.7 Timer mode
The pump’s on/off and running capacity could be commanded by timer, which could be programmed
daily as needed.
1
Enter timer setting by pressing
2
Press or to set the local time
3
Press to confirm and move to time-1 setting
4
Press or to choose the desired running periods, running capacity or flow
rate (when % icon is flashing, user can change to set the flow rate by pressing )
5
Repeat above steps to set other 3 timers
6
Hold 3 seconds to save setting and activate timer mode.
7
or Check 4 timers to make sure there is no invalid setting
Note:
When timer mode is activated, if the set time period contains the current time, the pump will start running
according to the set running capacity or flow rate. If the set time period does not contain the current time,
the timer number (1 or 2 or 3 or 4) that is about to start running will be displayed on the
controller and flash, will display the corresponding time period, indicating a
successful timer setting.
All 4 time periods should be set in chronological order. Overlap setting of time will be considered invalid,
the pump will only run based on the previous valid setting. If all 4 time periods set by the timer are invalid,
and will flash to remind the user, you can press to reset the time
period again to make sure they are valid.
During timer setting, if you want to return to the previous setting, hold both for 3 seconds. If
you don’t need to set all 4 timers, you can hold for 3 seconds, the system will automatically save
the current set value and activate the timer mode.