Page 2
MASTERS SERIES
®
1-5 H.P. HORIZONTAL
ASSEMBLY INSTRUCTIONS
WARNING: Read these instructions carefully. Failure to
follow these instructions could cause a malfunction of the
system. Improper installation, wiring or anchoring could
result in property damage or bodily injury.
This unit has been shipped partially assembled to avoid damage during shipment.
Please refer to enclosed drawings for part locations.
1. Carefully unpack your unit and inspect for damage.
NOTE: If steps 2-4 are already assembled by the factory, skip to Step 5 to
begin assembly.
2. To begin assembly, place the screened in power unit assembly on a at level
surface with the three sides of the screen exposed. Remove the plastic parts
bag from the screen. This parts bag contains the oat tube bolts, o-ring,
washers and nuts and silicone grease.
3. Install the o-ring provided in the groove on the elbow assembly (#2). Apply a
thin coat of silicone grease to the o-ring, groove and pump housing interior to
allow for easier installation. Insert the elbow assembly, with the open side of the
elbow pointing up. Insert four bolts, lock washers and at washers to secure the
elbow assembly in the pump housing.
4. Install the oat support bracket (#10) onto the back screen plate. Secure with
two self threading screws that are provided.
5. Install o-ring (provided) in the lower groove of the oat tube. Apply a thin coat
of silicone grease to the o-ring, oat tube and interior of the elbow to allow for
easier installation.
6. Lift oat assembly (#1) and insert oat tube into elbow (#2) making sure to align
the holes in the elbow with the holes in the oat tube.
7. Use a 3/8” at washer, bolt and nuts (#5) to secure the perimeter of the oat to
the rear bracket.
CAUTION: DO NOT operate without the suction screen in place.
8. Attach cable support grip (#9) on Anchoring “S” hook provided on the front
screen plate to keep strain off cable and cable disconnect assembly (#8).
9. Attach the AquaLock (ALC) connector.
CAUTION: HAND TIGHTEN ONLY! Do not use tools such
as a pipe wrench or pliers as you may over tighten and
damage the connectors.
Note: When your unit and/or lighting system requires removal, protective
caps have been provided to assist in maintaining a clean cable
environment. Simply hand tighten one half to your power unit and the other
half to your cable end. When you remove the protective caps, keep them in
a safe place, such as the control panel.
To Next Page
Loading...