AquaScape AquaSurge 2000-4000 User Manual (English)

Other manuals for AquaScape AquaSurge 2000-4000

Questions and Answers:

D
Diana NguyenJul 28, 2025
What to do if AquaScape Pond Pumps hums but doesn’t push water?
- E
  elizabeth69Jul 28, 2025
  If your AquaScape Pond Pump hums but doesn’t push water, it could be due to several reasons. The pump or plumbing may be clogged, so ensure nothing is blocking the intake. Additionally, clean the inner and outer screens, as well as the impeller rotor assembly and internal pump body. Verify that the pump is receiving the correct voltage and that the impeller blades are not worn or damaged.
J
Jennifer TorresAug 5, 2025
What to do if AquaScape Pond Pumps device won’t pair?
- P
  Paul WatsonAug 5, 2025
  If your AquaScape Pond Pump device won’t pair, start by ensuring the outlet is receiving power and that you have adequate wireless coverage to connect the device. If the issue persists, reset the device to factory defaults and make sure the Residual Current Device (RCD) is not tripped.
A
aaron92Aug 12, 2025
Why AquaScape Pond Pumps receiver displays an E2 message?
- C
  caseyjamieAug 13, 2025
  If your AquaScape Pond Pump receiver displays an E2 message, it indicates that the receiver is overheating. To resolve this, ensure the receiver is in a shady or cooler area away from direct, intense sunlight.
T
travis90Aug 20, 2025
Why AquaScape Pond Pumps receiver displays an E1 message?
- J
  Joseph CarpenterAug 20, 2025
  If your AquaScape Pond Pump receiver displays an E1 message, this means the input voltage going to the receiver is greater than 142 volts. Have an electrician inspect the outlet you have the receiver plugged into.