To Next PageTo Next Page
Need help?Do you have a question about the AquaTools AT11523 and is the answer not in the manual?
Perform specific checks before testing system pressure to ensure safety.
Instructions for mounting the trap to the pump body using screws and washers.
Guidelines for filter placement, ensuring level surface, drainage, and access.
Recommendations for pipe connections, materials, and leak prevention.
Guidance on installing ball or gate valves for servicing and system flow.
Compliance with local codes for wastewater discharge from filter backwashing.
Steps for assembling the filter unit and loading sand media correctly.
Detailed steps for installing the multiport valve and connecting system hoses.
Proper connection of the pump to a GFCI-protected circuit and wiring precautions.
Guidelines for ensuring correct voltage supply to the motor for optimal performance.
Procedures for cleaning the filter exterior and inspecting sand bed annually.
Checking system pressure, filter run time, and water chemical balance.
Maintaining proper water level and pH for system efficiency.
Steps for vacuuming the pool using the filtration system.
Steps for reactivation of the filter system after winter storage.
Procedures for installing and removing the drain fitting for filter draining.
Steps for removing and replacing the multiport valve handle.
Procedures for replacing the valve lid and plug assembly.
Step-by-step instructions for taking apart the pump for service.
Detailed steps for reassembling the pump after service or repair.
Addresses problems like pump not operating, low flow, or losing prime.
Troubleshooting repeated tripping of the circuit breaker or GFCI.
Addresses issues like short cycles between backwashes and low flow.
Solutions for unclear pool water and identifying sand in the pool.
General| Brand | AquaTools |
|---|---|
| Model | AT11523 |
| Category | Water Filtration Systems |
| Language | English |
