WARNING:
Caution:
Do not attempt to modify this product in any way without written authorisation from the manufacturer.
Power
This set operates on a DC supply provided by the AC-DC adaptor, the voltage is as indicated on the label
on the back cover. Use only the AC-DC adaptor supplied with your AQUAVISION® and never apply an
AC mains supply to the set directly. The AC-DC adaptor operates on an AC mains supply, the voltage is
as indicated on the label of the AC-DC adaptor.
Service
Never remove the front or back cover of the TV; this can expose you to high Voltage and other hazards. If
the TV is faulty in any way, switch it off and call your dealer. After any maintenance, you will need to
remove and clean off the original silicon and re seal the front joints as stated overleaf.
Location
Position your TV so that no bright light or sunlight will shine directly onto the screen.
Cleaning
When cleaning AQUAVISION®, never use an abrasive cleaner. The front of the screen is glass and
therefore should be cleaned with a soft damp cloth and a mild, non-abrasive glass/tile cleaning agent.
Earth
The unit must be earthed to the main earth system of the building and must conform to the latest
electrical safety regulations.
Installation
It is the installer’s responsibility to ensure that the AQUAVISION® unit is installed and sealed correctly as
stated in these instructions. Your guarantee will be void if any problems are caused through installation
faults or poor sealing. After any maintenance, you will need to completely clean the old silicon off and re-
seal as stated above.
Please note: The installation of your AQUAVISION® unit should be carried out by a technically competent
person and must conform to all the relevant regulations. If in doubt, please refer to your supplying dealer.
To Next Page