EasyManua.ls Logo

Aquavista 30-B410-BN-AV User Manual

Default Icon
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
11-26-2019
BATHROOM FAUCET WITH POP-UP DRAIN
ASSEMBLY
30-B410-BN-AV – Brushed nickel finish
PACKAGE AND HARDWARE CONTENTS
PART DESCRIPTION
QUANTITY
B
C
A
D
E
A
Faucet assembly
1
B
Lift rod assembly
1
C
Pop-up drain assembly
1
D
Mounting washer
2
E Mounting nut 2
SAFETY INFORMATION
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING
Protect your eyes with safety glasses when cutting or soldering water
supply lines.
CAUTION
If you solder the joints during installation, the seats, cartridges, and washers
must be removed before using a flame or the warranty will be voided on
these parts.
Cover the drain to avoid losing parts.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare
parts with package and hardware contents list. If any part is missing or damaged, do
not attempt to assemble the product. Contact customer service for replacement
parts.
Estimated Assembly Time: 30 minutes
Tools required for assembly (not included): adjustable wrenches, groove joint
pliers, pipe wrench, Phillips screwdriver, supply lines, thread seal tape, silicone.
Installation may vary depending on how the previous faucet was installed.
Supplies necessary for the installation of the faucet are not all included;
however, they are available wherever plumbing supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines, then turn
on the old faucet to release built-up pressure. When installing the new faucet,
hand tighten the connector nuts. DO NOT OVERTIGHTEN. Connections
that are too tight will reduce the integrity of the system.
Need Help? Please call our toll-free line at (877) 319-3757 (7:30 a.m. to 4:30 p.m. CST) for additional assistance or service.
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • HomewerksWW.com
Question and Answer IconNeed help?

Do you have a question about the Aquavista 30-B410-BN-AV and is the answer not in the manual?

Aquavista 30-B410-BN-AV Specifications

General IconGeneral
BrandAquavista
Model30-B410-BN-AV
CategoryPlumbing Product
LanguageEnglish

Summary

Package and Hardware Contents

Safety Information

Warning

Protect your eyes with safety glasses when cutting or soldering water supply lines.

Product Specifications

Assembly Instructions

Step 1: Turn off water supply

Turn off water, disconnect lines, clean area before mounting.

Step 2: Mount faucet body

Apply sealant, insert faucet, secure with washers and nuts.

Step 3: Connect water supply

Use supply lines, wrap tape, tighten fittings to faucet shanks.

Operating Instructions

Step 9: Post-installation checks

Remove aerator, run water, check for leaks, reattach aerator.

Troubleshooting

Faucet leaks underneath handle

Check bonnet, O-ring, cartridge for leaks.

Replacement Parts

Related product manuals