11
-27-20
1
9Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • HomewerksWW.com
KITCHEN FAUCET WITH PULL-DOWN SPRAY
AND OPTIONAL DECKPLATE
H70K-51D-AV-CH – Polished chrome finish
H70K-51D-AV-BN – Brushed nickel finish
PACKAGE AND HARDWARE CONTENTS
PART DESCRIPTION
QUANTITY
A
B C
G
D
E
F
A
Faucet body
1
B Lock nut
1
C Metal washer
1
D Hex bolt
2
E Optional deckplate
1
F Optional gasket
1
G Weight
1
SAFETY INFORMATION
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING
• Protect your eyes with safety glasses when cutting or soldering water
supply lines.
CAUTION
• If you solder the joints during installation, the seats, cartridges, and washers
must be removed before using a flame or the warranty will be voided on
these parts.
• Cover the drain to avoid losing parts.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare
parts with package and hardware contents list. If any part is missing or damaged,
do not attempt to assemble the product. Contact customer service for
replacement parts.
Estimated Assembly Time: 30 minutes
Tools required for assembly (not included): adjustable wrenches, groove joint
pliers, pipe wrench, Phillips screwdriver, supply lines, thread seal tape, silicone.
Installation may vary depending on how the previous faucet was installed.
Supplies necessary for the installation of the faucet are not all included;
however, they are available wherever plumbing supplies are sold.
Prior to beginning installation, turn off the hot and cold water lines, then turn
on the old faucet to release built-up pressure. When installing the new faucet,
hand tighten the connector nuts. DO NOT OVERTIGHTEN. Connections
that are too tight will reduce the integrity of the system.
Need Help? Please call our toll-free line at (877) 3
1
9-3757 (7:30 am to 4:30 pm CST) for additional assistance or service.
To Next Page
Need help?
General