To Next PageTo Next PageHow to turn on AR Blue Clean Washer?
To turn on your AR Blue Clean Washer, ensure the GFCI module on the power cord is plugged directly into an outlet, without using an extension cord. With the GFCI connected, turn the power switch on. Note that the power washer will turn on briefly (1-2 seconds) and then shut off; this is normal behavior.
What to do if AR Blue Clean Washer is running but no water?
If your AR Blue Clean Washer is running but no water is coming out, follow these steps: 1. Ensure the power is off until water flows through the spray gun to avoid motor damage. 2. Check the water source. 3. Remove the nozzle from the lance to see if the clog is in the nozzle. If so, refer to the nozzle cleaning instructions. 4. Remove the lance and spray directly from the spray gun to identify if the lance is the issue. 5. Inspect the garden hose adapter for loose connections and check the filter for any debris.
General| Brand | AR Blue Clean |
|---|---|
| Model | AR 143 S-Q2 |
| Category | Washer |
| Language | English |
Details GFCI protection for safety and risk reduction.
Provides guidance on normal motor operation and o-ring maintenance.
Explains how water pressure affects surfaces and how to control it.
Instructions on adjusting the soap concentration for the foam cannon.
Guidelines for using power washer detergents and application methods.
Procedure for cleaning the screen inside the garden hose adapter.
Steps to unclog or clean nozzles to maintain water pressure.
Instructions for proper storage, including protecting against freezing.
