What to do if sprayed fluid count displayed does not match liters/gpm actually sprayed on ARAG Control Systems?
If the sprayed fluid count displayed does not match the actual liters/gpm sprayed, it may be due to a wrong setup. Check the setup of the flowmeter constant and the type of section valves.
What to do if the instantaneous pressure is not displayed on ARAG Farm Equipment?
If the instantaneous pressure isn't showing on your ARAG Farm Equipment, there could be a few reasons. First, check the setup of the pressure sensor. Secondly, ensure that the computer is receiving signals from the pressure sensor. Finally, verify the connections to the pressure sensor, as incorrect installation might be the cause.
Why is the displayed speed not precise on my ARAG Farm Equipment?
An imprecise speed display on your ARAG Farm Equipment is often due to an incorrect wheel constant setup. Check the setup of the wheel constant.
What to do if the display does not switch on ARAG Farm Equipment?
If the display on your ARAG Farm Equipment doesn't turn on, first, ensure there is a power supply by checking the power supply cable connections. If the power is on, check if the computer is OFF and press the ON key.
Why is the distance traveled count displayed does not match actual distance covered on ARAG Farm Equipment?
If the distance traveled count displayed on your ARAG Farm Equipment doesn't match the actual distance covered, it might be due to a wrong setup. You should check the setup of the wheel constant and the connections to the speed sensor.
What to do if the display does not switch on ARAG bravo 350 Control Systems?
If the display does not switch on, it could be due to no power supply or because the computer is OFF. Check the power supply cable connections and press the ON key.
What to do if the display speed is not precise on ARAG Control Systems?
If the displayed speed is not precise, the setup of the wheel constant may be incorrect. Check the setup of the wheel constant.
Why is the instantaneous pressure readout inaccurate on ARAG Control Systems?
An inaccurate instantaneous pressure readout may be due to an incorrect setup of the full scale for the pressure sensor or a wrong installation of the pressure sensor. It's recommended to check the setup of the full scale for the pressure sensor and the connections to the pressure sensor.
Why valve controls take no effect on ARAG Farm Equipment?
If the valve controls on your ARAG Farm Equipment aren't working, it might be because the valves are not connected. Connect the connectors.
How to calibrate the displayed tank level on ARAG Farm Equipment if it is not precise?
If the displayed tank level on your ARAG Farm Equipment is not precise, it might be due to the level sensor. Perform the calibration, and if that doesn't work, calibrate the level sensor again. Also, check the connections to the level sensor, as incorrect installation could be the cause.
General| Display Type | LCD |
|---|---|
| Category | Control Systems |
| Display | LCD |
| Operating Voltage | 12 VDC |
| Housing Material | Plastic |
To Next Page
